Waterproof Coating

Product Details:

BULWARK PU 300 is single component, water Based POLYURETHANE COATING which is consists of specially developed polymers and properly selected components. BULWARK PU300 is not a usual Polyurethane coating is modified Polyurethane which cures by natural air, sunlight and gives Tough heavy duty Waterproof Membrane with extreme resistance for water and UV rays hence this can be applied on any Open Surface including Terrace and wall.
• Wherever water proofing need with high durability• Open Terrace• Any Open Surfaces• On Metal Roof• Exterior Side Walls
• Will Provide Tough, Heavy Duty slightly flexible water proof membrane.• Allows trapped vapor to escape thus preventing peeling and blistering.• Can be applied in uniform thickness to horizontal and vertical surfaces.• Develops excellent bond to most building materials.• BULWARK PU300 is not affected by ultraviolet light or by chemicals ranging from mild acids to strong alkalis.• BULWARK PU300 is non-flammable and does not give off toxic gases.• BULWARK PU300 is not harmful to the health of workman.

Product Details:

 BULWARK PU 500system must beapplied at temperature above 10⁰ C and below 40⁰ C.
 Primer must be as per recommendation orelse failure may occur.
 Must allow 5-6hrs interval between primer and Bulwark Poly 600.
 Must allow 2-3hrs interval between subsequent coat to avoid failure.
 Should not be diluted can use simple Graco Single Component Electric Airless Spray Machine.
 Suitable Tip must be selected to achieve 700-900 microns of thickness (Wet film)
 Recommended thickness not less than700-900microns (Wet film)
 Can be even applied by paint brush but ensure achieved 700-900 microns (wet film thickness)
 If apply on fiber mesh must ensure the fiber mesh is not visible and fully merged with PU 500.
 Soft /Hard Settling and Separation will be there needless to get panic just mix well and use. 

Product Details:

BULWARKPU500 is single component Polyurea coating which consists of specially developed hybrid polymers and properly selected components. Unlike traditional Polyurea bulwark PU 500 is hybrid Polyurea which is water based meanwhile this will possess all the properties of one traditional Polyurea possess it cures by natural air, sunlight and gives Tough heavy duty rough mate finish membrane with extreme resistance for water and UV rays hence this can be applied as Highend waterproofing system on concrete and can be covered with screed this also can be applied on Open Terrace without protective screed.
BULWARK PU 500 has excellent bonding strength hence instead replacing the GI sheets this can be used as a Anti corrosion cum expandable waterproofing coating on GI sheets. Due to its heavy tensile strength and excellent compatibility with cement mortarin order to save time and energy this can be used in the process of repairing an old terrace without removing weathering course andcan be applied even on the PCC before laying new tiles on it.